Electronic Water Timer（YL21025）

• Frequency can be set at 1, 2, 3, 4, 6, 8, 12, 24, 48, 72 H, and Week
• Run Time can be set at 1, 3, 5, 10, 15, 20, 30, 60, 90, 120 mins
• For taps with 26.5mm(G 3/4”) thread
• 2 x AAA alkaline batteries required(not included)

Why It Is the Easy Choice

• Two Turns and You Are Done: One dial sets the gap between waterings (1 hour to a full week). The other sets how long each session lasts (1–120 minutes). That is the whole setup.
• No Screen to Fail: With no LCD or app, there is nothing to misread, freeze, or forget. It is the most forgiving timer for beginners, kids helping in the garden, or rental properties.
• Tough Where It Counts: A sealed O-ring, tightened top cover, dirt-trapping filter, and water-resistant body shrug off rain, dust, and grit. It is built to live outside.
• Battery Just Runs the Valve: Two AAA alkaline cells power the motor that opens and closes the valve — not a power-hungry display. Long life, easy swap.
• Honest Battery Alert: The LED blinks once every 4 seconds when healthy, and blinks fast or stays steady when it is time for fresh batteries. No nasty surprises mid-summer.

How It Works (Spoiler: Two Turns)

• Frequency Dial: Choose how often to water: 1, 2, 3, 4, 6, 8, 12, 24, 48, 72 hours, or once a week.
• Run Time Dial: Choose how long each watering lasts: 1, 3, 5, 10, 15, 20, 30, 60, 90, or 120 minutes.
• It Counts Down and Repeats: The first watering starts one Frequency-interval after you set the dials, then repeats every interval. Want the first soak at a specific hour? Set the dials that many hours beforehand.
• Need Water Now?: Turn the Run Time dial to ON for instant manual watering, then back to OFF when done — no reprogramming.

Built to Survive the Garden

• Hand-Tighten Fit: A 3/4" (G3/4, 26.5 mm) tap adaptor with a collar ring clamps on by hand — no spanner, no pliers, no cracked plastic.
• Snap-On Hose: A male snap-on connector at the bottom takes your standard hose or sprinkler in a click.
• Self-Cleaning Filter: An internal filter traps dirt particles and extends the timer life; just rinse it now and then.
• Weather-Wise: Water-resistant and happy from 1°C to 60°C water, 0–8 bar pressure. Mount it above ground and vertical to the tap — never submerged.

Perfect For

• First-time timer buyers who want zero learning curve
• Holiday watering for lawns, pots, and veggie beds
• Greenhouses, allotments, and rental or Airbnb gardens
• Anyone who has fought with a fancy digital timer and lost

Heads-Up: This is a mechanical timer — brilliant in its simplicity, but it has no display or programs. One important rule: Frequency must always be longer than Run Time (e.g. you cannot set a 90-minute soak every single hour). The 2× AAA alkaline batteries are not included and should not be rechargeable. Use fresh cells at the start of each season.

Technical Specifications

Set It Up in Under a Minute

• Fit the Batteries: Slide out the battery compartment and insert 2 × fresh AAA alkaline batteries. Turn Run Time to ON briefly — you should hear the motor within 10 seconds — then back to OFF before connecting.
• Clamp to the Tap: Loosen the collar ring, screw the 3/4" tap adaptor onto your tap by hand, then lock it tight with the collar ring. No tools needed.
• Snap on the Hose: Click your hose or sprinkler onto the male snap-on connector at the bottom.
• Turn the Two Dials: Set Frequency (how often) and Run Time (how long). Wait about 3 seconds for the LED to confirm, and you are done.

Good to Know: The first watering starts one Frequency-interval after you set the dials, then repeats. To land the first soak at a set time, make your settings that many hours beforehand. After any change, wait ~3 seconds (LED flashes quickly) for the timer to validate. In winter or freezing weather, remove the timer, drain it, take out the batteries, and store it indoors.

Questions Buyers Ask

Q: Do I really just turn two dials?

A: Yes. Frequency = how often, Run Time = how long. There is no screen, no menu, and no app to learn — that is the whole point.

Q: How do I water right now without changing my settings?

A: Turn the Run Time dial to the ON position for instant manual watering, then back to OFF (or your usual setting) when finished.

Q: What batteries does it take?

A: Two AAA (LR03) 1.5V alkaline cells, not included. Use fresh alkaline batteries at the start of the season; do not use rechargeables.

Q: Will it fit my tap and hose?

A: The tap adaptor is a standard 3/4" (G3/4, 26.5 mm) thread with a hand-tightened collar ring, and the base has a male snap-on connector for a normal hose.

Q: Can it handle low water pressure?

A: Yes — it works from 0 bar up to 8 bar, so it is fine even on gravity-fed or low-pressure supplies.

Q: Is it waterproof?

A: It is water-resistant for outdoor use, not submersible. Mount it above ground and vertical to the tap, keep the top cover and O-ring sealed, and never immerse it.

Q: Why is my first watering later than I expected?

A: The timer starts its first cycle one Frequency-interval after you set the dials. Set the dials that many hours before your ideal start time to line it up.

The Simplest Way to a Watered Garden

No menus, no manuals, no meltdowns. The YL-21025 proves that good automation does not have to be complicated — two dials, two batteries, and your plants take care of themselves.